• 5-5-677/1,Second Floor, Sana Plaza,Goshamahal,Hyderabad
  • +91-40 -24741817, +91-40 -66565945
  • info@agrawalgrp.com
Doors

  • Use seasoned hardwood for door frames and apply wood preservatives on the door panel and frames prior to installation.
  • Ensure that the door frame sections are at exact right angles to each other to ensure perfect door panel fitment after planing.
  • The gap between the finished floor and the bottom edge of the door panel does not exceed 5 mm. It is recommended to use 6 mm teak wood lipping on door frames to increase the asthetic look and also to protect from termites and moisture.
  • It is recommended to use 6 mm teak wood lipping on door frames to increase the asthetic look and also to protect from termites and moisture.

Veneers

  • Wood veneers are selected for blueprint specifications to match in color and character for the desired project. Then they are carefully assembled to provide the most pleasing appearance for fixture manufacturing or wall paneling; thus achieving the desired beauty that architects and designers prefer over other materials. The natural characteristics of wood make it attractive to the eye when veneers are carefully selected for individual projects.
  • This method of panel matching achieves maximum grain continuity since all panels, doors, and other veneered components are made to the exact veneer sequence. If possible, flitches will be selected that will yield sufficient veneer to complete a prescribed area or room. If more than one flitch is required, the transition should be accomplished at the least noticeable location. This panel matching method is more expensive, but does express veneering in its most impressive manner.

Plywood and Block Board

  • Use masking tape on the lines you're cutting to prevent the plywood /block board from splintering.
  • Run screws into dowels planted at cross-angles rather than trying to drive them into end grain where they have no chance of sticking.
  • Use a second sheet of plywood/blockboard as a rip guide when no long straight edge is available.
  • In many applications it's possible to finish a sheet before cutting it; do this to save quite a bit of time.
  • Break edges by running sandpaper from inner portion of the plywood sheet outward to the open edge.
  • Always use backups to prevent tear-out when drilling.
  • In order to achieve the best results when installing plywood products, it is very important to use the proper size nail. The pattern for nailing that is used is also very critical.
  • Not all plywood/block board applications require the same size nail or spacing between nails.
  • You must check before you nail.
  • The spacing of nails on the edges of a panel frequently different from the spacing within the panel.